Software for control units

Here you can download software for all our control units.
Please remember to read the guidance.

CALIBRATOR ZURF
CALIBRATOR ICON
ISOBUS controller
ZURFcom
CALIBRATOR UNIQ

CALIBRATOR ZURF

3.01

See guidance Download software

CALIBRATOR ICON

V2.0.0

See guidance Download software

ISOBUS Controller (Gen I)

V20170714 / 2.2.0-2.02

See guidance Download software

ZURFcom

1.01

See guidance Download software

CALIBRATOR UNIQ (SN: 0-2327)

1.13

See guidance Download software

CALIBRATOR UNIQ (SN: 2328-X)

1.13

See guidance Download software

Guidance on updating

Guidance on Updating

1. Save the update file (ZURFxxx.ZBS) to your USB stick
2. On CALIBRATOR ZURF choose "MENU"
3. Choose "Data Transfer"
4. Choose "BOOTLOAD USB-stick"
5. Pick the file "ZURFxxx.ZBS

For further pieces of information – please read the “Data Transfer” section in the operator’s manual for CALIBRATOR ZURF!

Guidance on updating

1a. Connect CALIBRATOR ICON to the PC's COM port via a standard serial cable. The CALIBRATOR has to be turned off!

1b. Connect the CALIBRATOR to a stabile 12V power supply - e.g. a battery.

1c. Put the CALIBRATOR ICON into "Bootloader mode" by pressing the "ON" key for 5 sec. Bootloader mode is marked by a "data icon" on the screen.

2a. Download the update by clicking the icon in the right side menu - save it or run it directly.

2b. Choose com port in the program and press "Upgrade"

Your CALIBRATOR ICON has now been updated with the newest software.

Guidance on updating

When updating the ISOBUS Controller you'll need to download and install
these 3 programs.

1. Click to download TeeJet Pex Loader

2. Click to download TeeJet File Loader

3. Click to download BOGBALLE software

"Open" or "Run" to install the programs!

Guidance on updating ISOBUS Controller is to be found in the downloaded file (step 3) and will open automatically after the installation of "BOGBALLE software"

Please read the guidence!

-----------------

Please notice:
It's important to update both the ISOBUS board (2.2.0) and the ZURF board (2.0.2).

Guidance

Download the program.

"Open" or "Run" the program!

Guidance on updating

Download the update.

"Open" or "Run" to install the program!

Guidance on updating CALIBRATOR UNIQ is to be found in the downloaded file and will open automatically when you run the program.

Please read the guidence!

Test

Software for control units

CALIBRATOR ZURF

CALIBRATOR ICON

ISOBUS Controller (Gen I)

ZURFcom

CALIBRATOR UNIQ (SN: 0-2327)

CALIBRATOR UNIQ (SN: 2328-X)